Marantz VS3002 - Manual (Page 16)

11
ENGLISH
OTHER FUNCTIONS
AC IN AC IN
OFF OFF VP VP SR SR
OUTPUT OUTPUT REMOTE REMOTE LINK LINK
REMOTE REMOTE CONTROL CONTROL
EXTERNAL EXTERNAL INTERNAL INTERNAL
OUT OUT
IN IN FLASHER FLASHER IN IN RS-232C RS-232C
6 5 4 3 2 1
INPUT INPUT
2 1
DIGITAL R L VIDEO S-VIDEO AUX 1 INPUT AUDIO
VOLUME
UP DOWN
STANDBY
PHONES
M-DAX ENTER MENU
PURE DIRECT THX 7.1CH INPUT
MODE AUTO MULTI
A/B
T-MODE MEMORY CLEAR
DISPLAY
EXIT
SPEAKERS
BAND
MIC
PURE DIRECT
SURROUND SURROUND SPEAKER MULTI
M-DAX
POWER ON/OFF
STANDBY POWER
PAUSE PLAY
OPEN/CLOSE
STOP
ON/OFF LEVEL
+
PHONES
-
HDMI/DVI RESOLUTION
FL OFF
HDMI
INPUT1
HDMI
OUTPUT1
HDMI
OUTPUT
REMOTE
CONTROL
S-VIDEO
IN
S-VIDEO
OUT
IN
To a video device equipped with
HDMI
Video deck Amp
DVD player
HDMI
connection
Remote
connection
Set to SR
REMOTE LINK FUNCTION
When you perform the remote control connections for a Marantz amp or projector and set the
REMOTE LINK switch, the set device is switched automatically to HDMI input from other input
modes.
If you do not need to automatically switch the HDMI input, set the REMOTE LINK switch to
“OFF”.
The switch is set to “OFF” when the unit is shipped.
¶
The models (made by Marantz) that support the remote link function are as
follows. (As of September 2007)
• Amps SR4002, SR5002, SR7002, SR8002
• Projectors VP-10S1*, VP-11S1, VP-11S1H, VP-11S2, VP-12S2*, VP-12S3*,
VP-12S4, VP-13S1, VP-15S1
(* Devices that require an HDMI-DVI conversion connector)
7
When you want to control an amp:
Set the REMOTE LINK switch to “SR”
1. Connect the unit and the amp. Connect the HDMI INPUT 1 jack of the amp to the OUTPUT
1 jack of the unit.
Note:
This function only works when the HDMI INPUT 1 jack of an amp made by Marantz is
connected to the OUTPUT 1 jack of the unit. It will not function correctly when other jacks
are connected.
2. Perform the remote control connections for the unit and the amp.
3. Set the REMOTE LINK switch on the rear panel of the unit to “SR.”
4. When you press INPUT button 1 to 6 on the unit or remote controller, the amp is switched
automatically to HDMI input from other input modes (the S-Video jack in the connection
diagram).