Marantz VS3002 - Manual (Page 15)

10
ENGLISH
OTHER FUNCTIONS
AUTO INPUT FUNCTION (AUTO)
AUTO indicator
AUTO
button
AUTO button
Press the AUTO button on the unit or the remote controller to turn on the auto input function. The
AUTO indicator on the front panel lights up in blue.
When the auto input function is on, the unit monitors the input signals of the connected
devices. When the unit detects a new input signal, the input is automatically switched to the
corresponding device.
This function enables the unit’s input device to be automatically switched simply by connecting
or disconnecting cables or by turning on the power to a connected device.
The auto input function is on when the unit is shipped.
¶
Turning off the auto input function
Press one of the INPUT buttons from 1 to 6 on the unit or the remote controller. The auto input
function is turned off and the AUTO indicator on the front panel goes off.
Notes:
• The auto input function may not operate correctly with some connected devices.
• When the auto input function is on, you cannot turn it off by pressing the AUTO button
again.
EMPHASIS FUNCTION
EMPHASIS
indicator
EMPHASIS
button
EMPHASIS button
Press the EMPHASIS button on the unit or the remote controller to turn on the emphasis
function. The EMPHASIS indicator on the unit lights up in yellow. Press the EMPHASIS button
again to turn off the function.
When the emphasis function is on, if a signal that was input to the unit is then output again,
the signal is corrected before being output. This is useful when noise is generated in the output
video or audio. The effectiveness of this function depends on the connected devices and the
length and type of cables that are used. In particular, we recommend trying this function when
the output cable from the unit is 5 meters or longer. The effectiveness of this function may also
depend on your system. Test out your system when the function is on and the function is off, and
compare the results.
The emphasis function is on when the unit is shipped.
Notes:
• Sometimes, turning the emphasis function on or off makes no difference. (For example, when
the accuracy of the input signal is good.)
• If using this function has no significant effect, replace the cable with a shorter one.