Moxa Technologies INTELLIO C218 - Manual (Page 47)

Software Installation
Intellio C218Turbo /PCI User's Manual 3-29
In the “Basic Configuration” dialog, you should first press Enter in board type field
to select board type, C218Turbo/PCI. And then a list of
Intellio C218Turbo/PCI
boards found available is popped up for you to select. Normally, one choice is
available if there is one
Intellio C218Turbo/PCI board installed beforehand.
Press Enter on the desired entry of the list to select. Now the selected
Intellio
C218 Turbo/PCI board is configured with BIOS assigned memory address and
Bus/Device numbers as shown.
2. Press Page Down to enter “getty Setting” sub-dialog, there are some noticeable
fields for initialize the port for getty usage. You may skip this step if you will
not use getty utility.
Non-Modem and Modem Baud Rate
This field stands for the initial baud rate symbol and hunt sequence for Non-Modem
/Modem tty. It is simply for setting parameters of getty entries in system file /etc/inittab
which could also be manually modified by system administrator. Its value comes from
the UNIX system “getty default” file, i.e., “/etc/gettydefs”. Modify this field to suit your
need.
In some cases, you may need to modify the “getty default” file as well. For example,
in some UNIX systems, the “9600” symbol indicated 8-data-bit no-parity while in
others it may stand for 7-data-bit, even-parity. So, please examine the “getty
default” file carefully, and make sure the terminal settings is the same. Otherwise,
garbled data will be inevitable.