Marantz PMD620MKII - Manual (Page 27)

15
Preparations Before Use
AC adapter connection
When using the recorder with the provided AC adapter, follow
the procedure below to connect the AC adapter.
If you wish to use batteries, please refer to the Using batteries
section.
Notes:
• Only use the AC adapter that is provided with the recorder.
• Running the recorder on DC power without using the provided AC adapter
will cause damage to the recorder.
1.
Connect the plug of AC power pack into the DC IN jack on the
recorder.
2.
Connect the Power cord to a regular household plug socket.
LEVEL
OVER
RE C
REM OTE
DC IN
DISPL
AY
MENU/S
TORE
SKIP BA CK
REC PA USE
ST OP/CANCEL
VOL
ENTER
VO L
POWER
PHONES
LINE OU
T RET AKE
SOLID ST
ATE RECORDE
R PMD620
Using batteries
If you wish to run the recorder on battery power, follow the
procedure below to install batteries into the recorder. The
following types of battery can be used.
• Alkaline batteries (AA type)
• Nickel-Metal Hydride batteries (AA type)
Notes:
• When alkaline batteries (1450mAh type) are used recording: about 5 hours
• When running the recorder on batteries, always set the battery type in the
preset menu to the correct setting for the batteries used. ( v P.65)
• If the batteries run out during recording, recording automatically stops and
the file information is updated before the recorder shuts down.
• AC adapter is priority than battery. In both power driven, when the AC
adapter is taken off, the battery can backup and keep the all behavior on the
PMD620MKII.
1.
Check that the power is turned off.
2.
Slide and pull the battery compartment.