Milwaukee Heavy-Duty Sanders and Grinders - Manual (Page 10)

page 10
A Type 1 guard must be installed when using
a Type 1 cut-off wheel to provide maximum
protection for the operator if the wheel should break.
WARNING!
1. Unplug tool and place it upside down on a level surface. Remove any
accessories from spindle.
2. Loosen the guard screw and slip the guard over the spindle.
Position the guard in the location which offers best control and guard
protection. For operating zones that provide maximum protection for the
operator, see Fig. 9. Tighten the guard screw securely.
3. To adjust the guard, unplug the tool, loosen the guard screw, rotate the
guard to the desired position and retighten the guard screw.
4. To remove the adjusting shoe, loosen the wing nuts, slide the shoe over
to the access holes and lift out. To install the adjusting shoe, insert the
head of the carriage bolts into guard access holes and slide the shoe
over to the far edge of slots. Adjust shoe to desired position and tighten
wing nuts securely.
5. To remove the guard, unplug the tool, remove the accessories and
reverse the procedure.
Installing and Removing Type 1 Guard Assembly and Adjusting Shoe
(Fig. 12)
Fig. 12
Guard
Guard screw
Adjusting
shoe
Carriage bolt and wingnut
Spindle
Using Type 1 Cut-Off Wheels (Fig. 13)
1. Firmly grasp rear handle and side handle before starting and while us-
ing tool. Allow wheel to come to full speed before starting.
2. When using a cut-off wheel, hold tool as shown, using only the edge of
the wheel (Fig. 13).
3. Control pressure and surface contact between wheel and workpiece.
Too much pressure slows cutting speed.
Fig. 13
To reduce the risk of injury, never use a Type 1
cut-off wheel for surface grinding.
WARNING!