Milwaukee Heavy-Duty Sanders and Grinders - Manual (Page 12)

page 12
Maintaining Tools
Keep your tool in good repair by adopting a regular maintenance program.
Before use, examine the general condition of your tool. Inspect guards,
switches, tool cord set and extension cord for damage. Check for loose
screws, misalignment, binding of moving parts, improper mounting, broken
parts and any other condition that may affect its safe operation. If abnormal
noise or vibration occurs, turn the tool off immediately and have the problem
corrected before further use. Do not use a damaged tool. Tag damaged tools
“DO NOT USE” until repaired (see “Repairs”).
Under normal conditions, relubrication is not necessary until the motor brushes
need to be replaced. After six months to one year, depending on use, return
your tool to the nearest MILWAUKEE service facility for the following:
•
Lubrication
• Brush inspection and replacement
• Mechanical inspection and cleaning (gears, spindles, bearings,
housing, etc.)
• Electrical inspection (switch, cord, armature, etc.)
• Testing to assure proper mechanical and electrical operation
To reduce the risk of injury, always unplug your tool
before performing any maintenance. Never disas-
semble the tool or try to do any rewiring on the tool's
electrical system. Contact a MILWAUKEE service fa-
cility for ALL repairs.
To reduce the risk of injury, electric shock and dam-
age to the tool, never immerse your tool in liquid or
allow a liquid to flow inside the tool.
MAINTENANCE
For a complete listing of accessories refer to your MILWAUKEE Electric
Tool catalog. To obtain a catalog, contact your local distributor or a service
center listed on the back cover of this operator’s manual.
ACCESSORIES
Cleaning
Clean dust and debris from vents. Keep the tool handles clean, dry and free
of oil or grease. Use only mild soap and a damp cloth to clean your tool since
certain cleaning agents and solvents are harmful to plastics and other insu-
lated parts. Some of these include: gasoline, turpentine, lacquer thinner,
paint thinner, chlorinated cleaning solvents, ammonia and household deter-
gents containing ammonia. Never use flammable or combustible solvents
around tools.
Repairs
If your tool is damaged, return the entire tool to the nearest service center
listed on the back cover of this operator’s manual.
WARNING! WARNING!
WARRANTY
Every MILWAUKEE product is warranted to be free from defects in mate-
rial and workmanship. MILWAUKEE will repair or replace any product which
examination proves to be defective in material or workmanship.
Limitations: This warranty does not cover: 1) repairs made or attempted
by other than MILWAUKEE or MILWAUKEE Authorized Service Station
personnel; 2) normal wear and tear; 3) abuse; 4) misuse; 5) improper
maintenance; 6) continued use after partial failure; 7) tools that have been
modified; or product used with an improper accessory.
Battery Packs are warranted for one (1) year from the date of purchase.
Should a problem develop, return the complete product to any MILWAU-
KEE Factory Service Center or MILWAUKEE Authorized Service Station,
freight prepaid and insured. If inspection shows the problem is caused by
a defect in material or workmanship, all repairs or a replacement will be
made at no charge and the product will be returned, transportation pre-
paid. No other warranty, written or verbal, is authorized.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED HEREIN
ARE EXCLUSIVE. IN NO EVENT SHALL MILWAUKEE BE LIABLE FOR
ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, IN-
CLUDING LOSS OF PROFITS.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED
OR IMPLIED WHETHER FOR MERCHANTABILITY OR FITNESS FOR
PARTICULAR USE OR PURPOSE.
This warranty gives you specific legal rights. You may also have other
rights that vary from state to state. In those states that do not allow the
exclusion of implied warranties or limitations of incidental or conse-
quential damages, the above limitations or exclusions may not apply
to you.