Miller Electric XR Control - Manual (Page 23)

OM-1594 Page 17
5-5. Water-Cooled Gun Connections
Ref. 801 577-A / 801 563-D / Ref. 151 666-G
1 Gun Control Cable
Insert plug into Gun Control
receptacle, and tighten threaded
collar.
2
Gas Hose
3 Reed Relay
4 Weld Cable
5 Weld Cable Terminal In
Feeder
Route weld cable from welding
power source through reed relay to
weld cable terminal in feeder and
connect to weld cable terminal.
6
Gun Connector
7 Gun Securing Knob
8 Gun Connector Block
Loosen gun securing knob, and
insert gun connector through Wire
opening until it bottoms against
block. Tighten knob. Close and
latch door.
9
Water In Hose
Connect to Water In fitting on feeder
(left-hand threads).
10 Water Out Hose
Connect to Water Out fitting on
feeder (left-hand threads)
Close and latch door.
Tools Needed:
1
9
10
5 4
8
7
6
2
Left Side
3
9/16 in