Miele NOVOTRONIC T 7634 - Manual (Page 28)

Replacing the light bulb
Disconnect the dryer from the
electrical supply.
^ Open the door.
The hinged cover for the lighting is over
the port-hole.
^ Gently insert an ordinary tool* under
the side of the cover.
* such as a wide slot-type screwdriver
^ Open the cover by pressing lightly
while rotating your wrist.
The cover opens downwards.
The heat-resistant bulb should be
obtained only from Miele customer ser-
vice.
The bulb should be of the same type
and maximum wattage indicated on
the data plate and the lighting cover.
^ Replace the bulb.
^ Fold the cover upwards and press it
on the right and left until you hear it
latch.
,
Ensure that the cover is properly
seated. If moisture gets inside it may
cause a short-circuit.
Trouble shooting
28