Miele NOVOTRONIC T 7634 - Manual (Page 7)

~
The dryer should not be operated
without a vent duct.
~
It should not be connected to a
chimney used for other purposes.
~
Do not place the dryer in a room
where there is a risk of frost occurring.
Temperatures around freezing affect
dryer performance.
Acceptable room temperature should
lie between +2°C and +35°C.
~
Check all components of the venting
system (such as the wall pipe, external
grill, elbows and bends, etc.) for
airtightness. Lint can build up,
impeding airflow.
If a pre-existing system is present, it
should be checked before the dryer is
installed.
~
Ducting must not be connected to a
fireplace or gas flue that is in use, nor
to ducting which ventilates rooms with
fireplaces. Otherwise there is the
danger of smoke or exhaust gas being
driven back.
~
A suffocation and poisoning
hazard exists from suction of exhaust
gases, when gas water heaters, space
heaters, coal stoves with chimney
connections, etc., are installed in the
same room, or in the dwelling, or in
neighboring rooms and the under
pressure is 4 Pa or more.
Prevent underpressure by sufficient
room ventilation, by, for instance:
– unclosable ventilation openings in
the external wall, or
– a window switch:
the dryer can only be switched on
with the window open.
Safe operation and avoidance of an
underpressure of 4 Pa or more should
in any case be confirmed by your
Master Chimney Sweep.
~
Keep the room in which the dryer is
installed free of dust and fluff.
Dirt particles in the entering air promote
stoppages.
~
Do not support yourself or lean on
the door. The dryer might tip over.
~
Close the door after every drying
cycle. In this way you can prevent
– children from trying to climb into the
dryer or leaving objects inside it.
– small animals from getting into the
dryer.
~
Do not hose down the dryer.
Accessories
~
Accessory parts may only be
attached or installed when they have
been expressly approved by Miele.
If other parts are added or installed,
guarantee, performance and/or product
liability claims are invalidated.
The manufacturer will not be held
liable for damage caused by failure
to comply with the safety instructions
and warnings.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
7