Miller Electric S-21E - Manual (Page 27)

I,
O volts dc during spot Not used
time, 0.7 volts dc a~er
spot time with S51 in
Spot position, 0 volts
do with S51 in
contInuous position
‘4
+24 volts dc output
for motor stop/stan
circuitry with gun
trigger pressed, 0
volts dc after spot
time
IMPORTANT: For DC, the values are based on a good quality digital
volt-ohmmeter (DVM) or equivalent reading average (not RM5)
values. ForAC, the values are RMS readings. The DC voltages
shown are with respect to DC circuit common lead 71 (pin B ofplug
PLG5 I) unless otherwise indicated. The tolerances are ±10% unless
otherwise specified.
Burnback
potentiometer
R26
+24 volts dc output
for contactor output
with gun trigger pressed,
0 volts do after
burnback time
80-125 971
common
Not used
S-21E TM-1571 Page 23