Miller Electric RCT-224 Trailer - Manual (Page 11)

OM-6611 Page 9
3-5. Installing Taillight And Sidelight Wiring
802 814
Tools Needed:
Y Support trailer with jack. Block
wheels.
1 Wiring Clips
2 Grommet
Locate wiring harness (packaged with tail-
lights).
Route wiring harness leads through trailer
frame and out hole near axle. Slide grommet
over leads and install grommet in hole.
Route brown and green leads along axle to-
ward right wheel and brown and yellow leads
along axle to left wheel. Secure wiring to axle
with supplied cable ties.
Cut 45 in (1143 mm) from brown, green, and
yellow leads. Save cutoff wiring for connect-
ing side lights. Install taillights and sidelights
according to Section 3-10.
To install sidelight wiring: Use 45 in (1143
mm) wiring saved from taillight wiring to wire
sidelights. Separate brown leads from green
and yellow leads. Discard green and yellow
leads.
Splice sidelight short leads to wiring harness
brown leads using supplied tab connector
(see Section 3-6). Route brown leads along
top of frame and along back of crossmember.
Secure leads with wiring clips and cable ties.
Install wiring for other sidelight the same way.
Install sleeving on taillight and harness plug
electrical leads.
Brown
Lead
Brown And
Green Leads
Brown And
Yellow Leads
Use tab connectors to
splice sidelight brown
leads to taillight brown
leads. Tuck connector
through hole in frame.
1
Slide clips on frame
to secure wiring.
Brown
Lead
2