Miller Electric RCT-224 Trailer - Manual (Page 8)

OM-6611 Page 6
SECTION 3 − ASSEMBLY
This trailer is not compatible with equipment made prior to Serial No. LB033208.
All directions are given as facing the towing vehicle. The word “front” means the
hitch end of the trailer.
NOTE
3-1. Preparing Unit For Kit Installation
Ref. 190 250-A / Ref. 802 729
Y Stop engine, and let cool.
Disconnect battery negative
(−) cable.
Y Do not weld on base. Weld-
ing on base can cause fuel
tank fire or explosion. Weld
only on the four mounting
brackets or bolt unit down.
.
Go to Section 3-2 if mounting
brackets are already installed
as shown.
1 Mounting Bracket
2 3/8-16 x 1 in Screws
(Supplied)
Remove hardware securing the
rear mounting brackets to the base.
Reverse rear brackets and reattach
to base with original hardware.
Tighten hardware to 30 ft lb (41
N . m).
Tools Needed:
9/16 in
1
2