Miller Electric XMC 4000 - Manual (Page 21)

OM-221 694 Page 17
4-4. Wire Type Selection In Synergic MIG Or Synergic Pulsed MIG Welding
1 L5 LED
2 L6 LED
3 L7 LED
4 L8 LED
5 P4 Push Button
Press P4 until desired material LED illumi-
nates. D1 and D2 will show material name
only momentarily, and then return to the
main display.
.
D1 and D2 will show NO PROG or a
selection will not be allowed when
there is no program for the process,
material, wire diameter, and shielding
gas combination.
L5 selection is for carbon steel.
L6 selection is for stainless steel.
L7 selection is for aluminum.
L8 selection is for other wire types not pro-
vided by standard selection.
Pressing P2 push button after a selection
is made to allow choosing other wire types
within the main selection.
SG2/3 allows selecting SG2 or SG3.
CrNi allows selecting 308L, 309L, or 316L.
Al allows selecting AlMg (AlMg5) or AlSi
(AlSi5).
Special allows selecting cored wire or spe-
cial wire (abbreviations for the different
wire types will appear on D1 and D2).
.
Be aware that the wire type selection is
retained in the welding process
memory until a new selection is made.
L5
L6
L7
L8
P4
4-5. Wire Diameter Selection In Synergic MIG Or Synergic Pulsed MIG Welding
1 L9 LED
2 L10 LED
3 L11 LED
4 L12 LED
5 P5 Push Button
Press P5 until desired wire diameter LED
illuminates. D1 and D2 will show trim in m/
min values.
.
D1 and D2 will show NO PROG or a
selection will not be allowed when
there is no program for the process,
material, wire diameter, and shielding
gas combination.
L9 selection is for 0.8 mm diameter wire.
L10 selection is for 1.0 mm diameter wire.
L11 selection is for 1.2 mm diameter wire.
L12 selection is for other wire diameters not
provided by standard selection.
Pressing P2 push button after the special
selection is made to allow choosing other
wire diameters not available by standard
selection.
L9
L10
L11
L12
P5