Miller Electric Millermatic 350 - Manual (Page 56)

OM-1327 Page 52
SECTION 8 − PARTS LIST
8-1. Drive Roll And Wire Guide Kits
.
Base selection of drive rolls upon the following recommended usages:
1 V-Grooved rolls for hard wire.
2 U-Grooved rolls for soft and soft shelled cored wires.
3 U-Cogged rolls for extremely soft shelled wires (usually hard surfacing types).
4 V-Knurled rolls for hard shelled cored wires.
5 Drive roll types may be mixed to suit particular requirements (e.g. V-Knurled
roll in combination with U-Grooved).
Wire Diameter
Fraction Decimal Metric
.023/.025 in
.030 in
.035 in
.045 in
.052 in
1/16 in
.035 in
.045 in
.052 in
1/16 in
.035 in
.045 in
.052 in
1/16 in
.023/.025 in
.030 in
.035 in
.045 in
.052 in
.062 in
.035 in
.045 in
.052 in
.062 in
.035 in
.045 in
.052 in
.062 in
0.6 mm
0.8 mm
0.9 mm
1.2 mm
1.3 mm
1.6 mm
0.9 mm
1.2 mm
1.3 mm
1.6 mm
0.9 mm
1.2 mm
1.3 mm
1.6 mm
Kit No.
087 132
046 780
046 781
046 782
046 783
046 784
044 750
046 785
046 786
046 787
046 792
046 793
046 794
046 795
Drive Roll
Part No. Type
087 130
053 695
053 700
053 697
053 698
053 699
072 000
053 701
053 702
053 706
132 958
132 957
132 956
132 955
V-Grooved
V-Grooved
V-Grooved
V-Grooved
V-Grooved
V-Grooved
U-Grooved
U-Grooved
U-Grooved
U-Grooved
V-Knurled
V-Knurled
V-Knurled
V-Knurled
Wire Guide
Inlet Intermediate
056 192
056 192
056 192
056 193
056 193
056 195
056 192
056 193
056 193
056 195
056 192
056 193
056 193
056 195
056 206
056 206
056 206
056 207
056 207
056 209
056 206
056 207
056 207
056 209
056 206
056 207
056 207
056 209
Ref. S-0025-D
.
A complete Parts List is available at www.MillerWelds.com