Metrologic Instruments MS9544 - Manual (Page 39)

35
D EFAULT S ETTINGS
Many functions of the scanner can be configured or enabled/disabled.
The scanner is shipped from the factory configured to a set of default conditions.
All default parameters of the scanner have an asterisk (
*
) marked in the default
column. If an asterisk is not in the default column then the default setting is off or
disabled. Every interface does not support every parameter. A check mark ( )
will appear in the interface column if it supports the parameter listed.
PARAMETER DEFAULT OCIA RS232
LIGHT
PEN
IBM
46XX
KBW USB
LASER
EMULATION
Normal Scan Mode *
Continuous Scan Mode
Blinky Scan
Continuous Blinky Scan
Custom (one shot) Scan
Long-Range In-Stand *
Short-Range In-Stand
Long-Range Out-of-Stand *
Short-Range Out-of-Stand
CodeGate Active In-Stand
CodeGate Inactive In-Stand *
CodeGate Active Out-of-Stand *
CodeGate Inactive
Out-of-Stand
UPC/EAN *
Code 128 *
Code 93 *
Codabar *
Interleaved 2 of 5 (ITF) *
MOD 10 check on ITF
Code 11
Code 39 *
Full ASCII Code 39
PDF *
PDF CodeGate Active
Out-of-Stand