Muratec MFX-1200 - Manual (Page 19)

1.8
Getting started
Turning off the transport mode
Important: After unlocking the mirror carriage (see page 1.5), you must turn the
transport mode off by following procedures.
When the machine is in the transport mode, the LCD shows:
To turn off the transport mode:
1 Press Program key, *, E .
2 Select Off by pressing or . Then press ENTER to turn off the transport
mode. The mirror carriage will move to the home position.
Important: If you must reship the machine, turn on this mode to move the mirror
carriage to the transport position (in step 2, above, press or to
set the transport mode to On), then power off and lock the mirror car-
riage using the mirror carriage locking plate (see page 1.5).
Adjust the monitor speaker s volume
You can set the volume of the monitor speaker.
1 Press MONITOR / CALL on the control panel. You now should hear a dial tone.
And press or of the cursor key. The LCD indicates the volume:
2 To turn the volume up, press .
To turn the volume down, press .
3 Press MONITOR / CALL again to hang up.
Loading paper
Acceptable paper size and cassette capacity
Paper source Paper type Paper size Capacity
Paper cassette Plain paper* 1 Letter , Legal , Half-letter 500 sheets
Letter , Legal , Half-letter ,
Plain paper* 1 A4 , A5 , A6 , F4 , 50 sheets
Bypass Tray Executive , Custom-sized* 2
Envelopes DL , CM10 , Monarch 1 sheet
Postcard 3.9 ″ Ч 5.8 ″
(100 Ч 148mm) 20 sheets
Transparency* 3 Letter 20 sheets
* 1 Paper weight: 60 90 g/m 2
* 2 (3.8 8.5) inches (5.5 14.0) inches (Width Length) : It only can use if the
optional Printer Controller is attached.
* 3 We recommend: 3M PP2500 for laser printers or equivalent
Note: Do not use any paper which has been creased, wrinkled or has absorbed any
moisture.
Loading paper in paper cassette
Before you load paper, note the following:
After you loaded paper in paper cassette, you must need to tell your machine
which size of the paper, letter-, legal- or half letter-sized, you loaded.
You can do this by the Setting of the paper size operation. (See next page.)
Note: If you will be using letter-sized paper, there s no need to adjust the cas-
sette; your machine is initially set for Letter-sized paper. Simply attach
the LTR sticker to the outside of the paper cassette.
1 Open the paper cassette from the front of your machine by gently pulling it
toward you.
* * Tel Mode **
Volume:
n n n n n n
Mirror Locked :Off
← ←
/
→ →
/Enter
Mirror Locked :On
← ←
/
→ →
/Enter
Mirror Locked