Muratec MFX-1200 - Manual (Page 96)

Advanced features
18 Press ENTER . The LCD asks you to select a contrast mode for each programma-
ble one-touch number.
19 Press until the mode you want appears.
20 Press ENTER . The LCD asks if you want the memory transmission on or off
when using this programmable one-touch number.
21 Press until the mode you want appears.
22 Press ENTER . The LCD asks you for the type of confirmation report you want to
set for this programmable one-touch number.
23 Press until the mode you want appears.
24 Press ENTER . The LCD asks if you want to send a cover page for this program-
mable one-touch number.
25 Press until the mode you want appears.
26 Press ENTER . The LCD asks if you want to turn the Fax & Copy feature on or
off for this programmable one-touch number.
Note: When the memory transmission is set to off in step 20, this LCD will
not appear and go to step 29.
27 Press until the mode you want appears.
28 Press ENTER .
29 Press STOP to return your machine to standby mode.
Programming F-Code polling
For this operation to work, two things must be true:
The document which you re polling must exist in the remote fax s F-Code box ( ITU - T
standard sub-addressing/password box).
You must know the remote fax s
ITU - T sub-address and password (if any) for each
box you want to poll.
To program an F-Code polling operating into a programmable one-touch key:
1 Press Program key, A , 3, 0, 1, ENTER . The LCD shows the first empty pro-
grammable one-touch number available:
Note: If P2 appears on the LCD , it means that you have already entered a
number for P1. You can see what you programmed into P1 by press-
ing , if you want. For example, if you set P1 for storing of the polling
document, you will see:
Press to go back to the programmable one-touch key you want to
enter.
Note: To erase a programmable one-touch key, see page 3.49.
2 Press the key that you want to program or change. Here, we ve selected P2.
Note: If your previous command for this key was for an F-Code polling oper-
ation and you want to keep this key programmed for an F-Code
polling operation, use these instructions to make changes. But if you
want to assign this key to a completely different operation (for a
delayed transmission, for example), then you first must erase the
stored command before programming the new one.
3 If you want to select a different programmable one-touch key than the one
that appears on the
LCD , press that key now.
4 Press ENTER . The LCD asks which operation you want to program into the pro-
grammable one-touch:
Type :Communication
← ←/→ →/Enter
Select Program No.
P2:No Number Stored
Select Program No.
P1:Polling Document
Select Program No.
P2:No Number Stored
Fax & Copy :---
← ←/→ →/Enter
Cover Page :---
← ←/→ →/Enter
Report :---
← ←/→ →/Enter
Memory Tx :---
← ←/→ →/Enter
Contrast :-------
← ←/→ →/Enter
3.43