Muratec MFX-1200 - Manual (Page 43)

2.12
Basic operation
Your machine s copier features
Your machine has the following copier features:
Single copy (see the right column on this page)
Stacking multiple copies (see page 2.12)
Sorting multiple copies (see page 2.12)
Enlarged or reduced copies (see page 2.13)
Negative/positive copy (Reverse black and white areas) (see page 2.16)
Combine copy (see page 2.17)
Ultra copy mode (see page 2.17)
Basic copy procedure
1 Press COPY / FAX to change to
Copy mode.
When the machine is in the Copy mode, the LCD shows:
Note: For details about each item, see Making copy settings, page 2.15
2 Place your original document in ADF face up, or on the FBS glass face
down just as you would to send a fax.
3 Enter the document size by pressing the DOCUMENT SIZE .
4 As needed, set the following:
Select document type and adjust image contrast
Enter the number of copies
Set copy reduction or enlargement ratio
Note: For details about each item, see Making copy settings, page 2.15.
5 Press START .
Note: To reset the copy parameter to default setting, press COPY RESET .
Note: To stop the copying, press STOP .
Single copy
1 Press COPY / FAX to change to Copy mode.
2 Place your original document in ADF face up, or on the FBS glass face
down just as you would to send a fax.
3 If you are using FBS glass, enter the document size by pressing the
DOCUMENT SIZE .
4 As needed, set the following:
Select document type and adjust image contrast
Set copy reduction or enlargement ratio
Note: If you want to enlarge copy, use the FBS glass.
5 Press START .
Number of copies
Copy reduction or enlargement ratio
Recording paper size
Document size
COPY/FAX key
Making copies