Miller Electric OM-230 - Manual (Page 19)

.
A complete Parts List is available at www.MillerWelds.com
OM-230 693 Page 15
4-7. Connecting XR Aluma-Pro, XR Edge, XR-A Gun, Or XR-A Python
Ref. 804 910-A / 804 936-A
.
XR Edge guns prior to serial no.
LE079101 require an adapter
cord (part no. 195 498).
1 Gun End
2 Gun Liner
3 Wire Outlet Guide
Trim excess liner from end of gun
so no more than 3/32 in (2.4 mm) of
liner extends past wire outlet guide.
4 Gun Securing Knob
Loosen securing knob. Insert gun
end through opening until it bottoms
against drive assembly (make sure
gun end does not touch drive rolls).
Tighten knob.
Be sure to change drive rolls to the
proper size and type.
5 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
.
If Aluma-Pro push/pull gun has
a listed SUP value, set the
power source to match the
SUP value (see Section 5-5).
3 2
3/32 in
(2.4 mm)
.
Be sure to trim liner to proper extension.
5
4
1