Marantz VP8100 - Manual (Page 8)

4
INTRODUCTION
ENGLISH
z COMPONENT VIDEO IN
Y, P B /C B , P R /C R connectors.
Connect to the COMPONENT VIDEO output of video
equipment or an A/V processor/receiver with a component
video loop.
x S-VIDEO IN
Connect to the S-VIDEO output of a video equipment.
c VIDEO IN
Connect to the composite video output of a video equipment.
v RGB IN
Connect to the analog RGB output of a computer equipment.
b REMOTE SW. (EXTERNAL/INTERNAL)
When using the MARANTZ REMOTE CONTROL system, select
EXTERNAL. Otherwise select INTERNAL.
n REMOTE CONTROL IN/OUT
Connect to the REMOTE CONTROL connectors of other
Marantz equipment. It is then possible to control the whole
system with a single Remote Controller.
m TRIG.1 OUT
When the projector is turned on, a 12-volt signal is sent to the
equipment connected to the TRIG.1 OUT. This allows
automatic triggering of an accessory, such as a powered
up/down screen, whenever the projector is turned on or off.
When the unit is turned off, no voltage is output and when the
unit is turned on, 12 V is output.
Note:
You cannot use the connector as the power source.
, TRIG.2 OUT
Either A 12-volt signal or a 0-volt signal is sent to the
equipment connected to the TRIG.2 OUT, according to the
setting in the OSD menu.
Note:
This cannot be used for these connectors, TRIG.1 OUT and
TRIG.2 OUT, as the power source.
. Adjuster button
When using adjuster, press the button and loosen an adjuster.
⁄0 Adjuster
⁄1 Rear adjuster
Adjust the vertical angle of the projector.
⁄2 Ventilation holes
⁄3 IR sensor
⁄4 AC IN
Connect the supplied AC power cord.
EXT. INT. OUT
TRIG.2
REMOTE CONTROL
TRIG.1 RGB IN Y P B /C B
COMPONENT VIDEO IN S-VIDEO
IN
VIDEO IN
P R /C R
IN
n b c ⁄0 ⁄3 ⁄2
m , v z x
⁄4 ⁄1 ⁄2 ⁄0 ⁄0
.
Connector panel and Rear