Miller Electric Axcess 300 - Manual (Page 18)

OM-230 032 Page 12
1 Warning! Watch Out! There are
possible hazards as shown by the
symbols.
2 Electric shock from wiring can kill.
3 Disconnect input plug or power
before working on machine.
4 Hazardous voltage remains on input
capacitors after power is turned off.
Do not touch fully charged
capacitors.
5 Always wait 5 minutes after power is
turned off before working on unit, OR
6 Check input capacitor voltage, and
be sure it is near 0 before touching
any parts.
7 When power is applied failed parts
can explode or cause other parts to
explode.
8 Flying pieces of parts can cause
injury. Always wear a face shield
when servicing unit.
9 Always wear long sleeves and button
your collar when servicing unit.
10 After taking proper precautions as
shown, connect power to unit.
4/04
219 844−A
> 5 min
V
V
V
1 2 3 4 5 6
7 8 9 10
S-179 309-A
∠
= <60
°
∠
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Falling equipment can cause
injury and damage to unit.
3 Always lift and support unit
using both eye bolts. Keep
angle of lifting device less
than 60 degrees.
4 Use a proper cart to move
unit.
5 Do not use one eye bolt to lift
or support unit.
1/96
1
2 3 4 5
3-2. WEEE Label
Do not discard this product with
general waste.
Reuse or recycle Waste Electrical
and Electronic Equipment (WEEE)
by disposing at a designated collec-
tion facility.
Contact your local recycling office
or your local distributor for further
information.