Connecting to weld terminals, 8. connecting to weld terminals – Miller Electric Axcess 300 User Manual

Page 24

Advertising
background image

OM-230 032 Page 18

4-8.

Connecting To Weld Terminals

1

2

Ref. 803 667-A / 803 778-A

!

Turn off power before connecting to
weld output terminals.

!

Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your
machine.

Determine total cable length in weld circuit
(both positive and negative cables com-
bined) and maximum welding amperes.

See Section 5-1 to select proper cable size.

1

Positive (+) Weld Output Terminal

2

Negative (−) Weld Output Terminal

Connect positive weld cable to Positive (+)
weld terminal and negative (−) cable to
Negative weld terminal.

3

Weld Output Terminal

4

Supplied Weld Output Terminal Nut

5

Weld Cable Terminal

6

Copper Bar

Remove supplied nut from weld output
terminal. Slide weld cable terminal onto
weld output terminal and secure with nut so
that weld cable terminal is tight against
copper bar. Do not place anything
between weld cable terminal and copper
bar. Make sure that the surfaces of the
weld cable terminal and copper bar are
clean.

Tools Needed:

3/4 in (19 mm)

6

4

5

Do not place

anything between

Correct Installation

Incorrect Installation

3

weld cable terminal

and copper bar.

.

If using an electrode negative (straight polarity)
process, the volt sense lead must be connected
to the work.

Advertising