Minicom Advanced Systems 5UM70166 - Manual (Page 9)

USER GUIDE
8
Computer rack
ProL ian t DL 360
9. 1 - GB 1 0k UL TRA2 SCSI 9 .1 - G B 1 0k ULTRA 2 SCSI
ProL ian t DL 360
9. 1 - GB 1 0k UL TRA2 SCSI 9 .1 - G B 1 0k ULTRA 2 SCSI
ProL ian t DL 360
9. 1 - GB 1 0k UL TRA2 SCSI 9 .1 - G B 1 0k ULTRA 2 SCSI
ProL ian t DL 360
9. 1 - GB 1 0k UL TRA2 SCSI 9 .1 - G B 1 0k ULTRA 2 SCSI
ProL ian t DL 360
9. 1 - GB 1 0k UL TRA2 SCSI 9 .1 - G B 1 0k ULTRA 2 SCSI
ProL ian t DL 360
9. 1 - GB 1 0k UL TRA2 SCSI 9 .1 - G B 1 0k ULTRA 2 SCSI
COMPUTER 1 COMPUTER 2
COMPUTER 6 COMPUTER 5 STATION 2
SCREEN PS/2 MOUSE KB POWER
SERIAL MOUSE
COMPUTER 3 COMPUTER 4
COMPUTER 8 COMPUTER 7
KVM switch
SD P110
KVM cable
LAN / WAN
User over IP
MINIC O M
IP CONTROL
LAN
MINIC O M
Figure 4 IP Control connections to a KVM switch
10. Initial settings
The following sections provide instructions for setting the IP address for the IP
Control unit.
11. Default IP address
By default, IP Control boots with an automatically assigned IP address from a
DHCP (Dynamic Host Configuration Protocol) server on the network. The DHCP
server provides a valid IP address, gateway address and subnet mask.
To identify the IP address, the IP Control MAC address appears on the underside of
the IP Control box. The device number (D.N.) can also be found there.
If no DHCP server is found on the network, IP Control boots with the static IP
address
: 192.168.0.155.
Note! If a DHCP server later becomes available, the unit picks up the IP settings
from DHCP server. To keep the static IP address, disable DHCP – explained in
section
13.1 on page 10.