Marantz DLPTM VP-12S3/VP-12S3L - Manual (Page 36)

ENGLISH
30
The following adjustments can be made:
– Auto Power Off
When the auto power off feature is turned on, power to the projector automatically shuts off if no signals are received and no
operations are performed for about 10 consecutive minutes. If 9 minutes pass without the projector receiving any signals or
being operated in anyway, the below message appears on the screen.
About 1 minute after the message appears on the screen, power to the projector shuts off.
Note:
After the above message appears on the screen, pressing any button on the projector or remote control other than the POWER
button on the projector and the POWER ON or STANDBY buttons on the remote control resets the auto power off feature.
The auto power off feature will activate again if, after that, the projector goes without receiving any signals or being operated in
anyway for 10 consecutive minutes.
– OSD Position (16:9 / 4:3)
OSD position is selected from 16:9, 4:3 and Through.
– Color Temp. Calibration
After replacing the lamp or in other cases where the lighting changes, color temperature can be adjusted using the included
color temperature sensor. For more information on how to adjust color temperature, see “Color Temperature Adjustment” (
☞
P.36).
– Reset Lamp Life
If the lamp is replaced before reaching its 2000 hours lamp life, be sure to reset the lamp’s life counter. To do this, select
“Reset Lamp Life” from the Configuration menu. When you do so, the below message appears on the screen.
Again, select “Yes”, and press the ENTER button. Then the lamp life is initialized.
Yes No
Reset Lamp Life ?
Through OSD position 4 : 3 OSD position 16 : 9 OSD position
Picture Adjust
Menu Standard1
Setting
Display
System
Config
Trigger 2
Preset
Contrast
Brightness
Color
Sharpness
Tint
Noise Reduction
Color Temp.
Fine Menu
50
44
58
7
0
0
3
Picture Adjust
Menu Standard1
Setting
Display
System
Config
Trigger 2
Preset
Contrast
Brightness
Color
Sharpness
Tint
Noise Reduction
Color Temp.
Fine Menu
50
44
58
7
0
0
3
Picture Adjust
Menu Standard1
Setting
Display
System
Config
Trigger 2
Preset
Contrast
Brightness
Color
Sharpness
Tint
Noise Reduction
Color Temp.
Fine Menu
50
44
58
7
0
0
3
It will be standby mode soon.
Auto Power Off
Picture Adjust
Menu User A1
Setting
Display
System
Config
Trigger 2
Preset
Auto Power Off
OSD Position
Language
Ceiling
Rear
Color Temp. Calibration
Reset Lamp Life
Reset All
Disable
16:9
Off
English
Off
Configuration
Auto Power Off Enable, Disable
OSD Position 16:9, 4:3, Through
Language
English, German, French, Spanish,
Portuguese, Italian
Ceiling On, Off
On: The picture is reversed horizontally
and vertically.
Rear On, Off
On: The picture is reversed horizontally.
Color Temp. Yes, No
Calibration
Reset Lamp Life Yes, No
Reset All
Yes, No