Motorola MEA 3.1 - Manual (Page 10)

2 Device Installation
2.1 Software Requirements
Two types of software interfaces will be required during the installation and setup process of the
VMM3600 device: MeshManager and the VMM Device Administration web interface.
MeshManager software needs to be installed and running on a network computer prior to VMM
installation and configuration. MeshManager will be used in the VMM setup process to validate
the installation of the device. In addition, MeshManager will be used to manage a VMM and
other subscriber devices within the MEA network.
The VMM Device Administration web interface is used to administer and configure the device
and can be accessed by connecting a PC to the wired interface. Additional information is
provided later in the manual.
Detailed information about MeshManager software and its usage is found in the following
publications: MeshManager User’s Guide and QuickStart for MeshManager.
2.2 Equipment Requirements
A VMM6300 is utilized similarly to a subscriber device within a MEA network and will be used
with the IAP6300 and MWR6300 infrastructure devices.
The following list defines the standard MEA hardware components to install a VMM:
• N-type Antenna Connector
• 0dBi Antenna (supplied)
• 15 foot cable assembly
The Network Operator must supply the following:
• Mounting
Location
• Power Source (12V DC) (from vehicle or other DC power supply)
• A Hub or Switch (if more then 1 Ethernet device will be used)
• Hand tools for bracket installation
2