Motorola MEA 3.1 - Manual (Page 12)

2.4 VMM6300 Assembly Information
The VMM6300 Assembly shows the external connection points on a VMM6300 box.
N-Type
Antenna
Connector
Power
Reset Power
Connector
Ethernet
(Crossover MDI-X)
Figure 2-1. VMM External Connection Point
2.5 Installing the VMM6300 Device
The following instructions describe the VMM6300 hardware installation procedure:
1. Mount the VMM box in a suitable location in a vehicle to allow for ventilation. Note
that the device is not waterproof and should be reasonably protected from moisture
and other exposed outdoor environments.
2. Connect the antenna to the N-type connector.
3. Insert the Power Plug into Power Connector.
4. Verify that both MAC addresses have been recorded in Section 2.3.1, as this
information will be required to configure and test the device.
5. If installing more than one IP device to the VMM6300, a separate hub device can be
connected to the VMM ETH port. Up to three IP devices can be provisioned to
interface with the VMM.
NOTE: For more information about how to configure additional devices to the VMM,
refer to the
External Device Provisioning section of this manual.
4