Maytag MAH7550AGW - Manual (Page 6)

5
O
PERATING
I
NSTRUCTIONS CONT
.
C
LOSE THE
W
ASHER
D
OOR
• To load a forgotten item, press the Start/Pause touchpad, wait for the washer to stop and the door to unlock, add the
item(s), close the door and press the Start/Pause touchpad. After a 30 second pause, the programme will resume.
NOTE: To assure that your additional item(s) get clean, do not wait more than ten minutes after the programme has
started to add the item(s).
A
DD
L
AUNDRY
D
ETERGENT AND
A
DDITIVES TO THE
D
ISPENSER
The automatic dispenser consists of three compartments for:
1. Liquid or granular detergent for main wash.
2. Liquid or granular detergent for pre-wash.
3. Liquid fabric softener.
All laundry products can be added at once in their respective dispenser compartments. They will
be dispensed at the appropriate time for most effective cleaning.
NOTE: It is important to pay close attention to the soil level of the load, load size, and water
hardness* and to use the appropriate amount of detergent to reduce or eliminate suds. When
less suds are produced, the load tumbles more efficiently and cleaning results are maximized. To
avoid over-sudsing, reduce the amount of detergent used with soft water or with small or lightly
soiled loads.
* To determine water hardness in your area, contact your local water utility.
Either liquid or granular detergent may be used in the main wash compartment to wash clothes. Follow
the directions on the box or bottle to determine the appropriate amount of detergent to pour into its
compartment. Do not exceed 500ml of granular detergent in the main wash compartment. When using
liquid detergent, do not exceed the level on the bottom of the siphon cap marked by an arrow. Usually
about 240ml of liquid will fill the cup to this mark.
The dispenser is shipped from the factory ready to be used with liquid detergent (all liquid cups and siphon caps are installed). If
you wish to use granular detergent, you need to remove these items first. You can remove these items by following the steps
below (in the future, if using liquid detergent, the liquid detergent cup and siphon cap must be installed in the dispenser):
1. Remove the main cup assembly, (with siphon cap and liquid cup installed), from the dispenser by pulling up and out on the cup.
2. Remove main liquid siphon cap from the assembly.
3. Remove main liquid cup from assembly.
4. Reinstall the main cup back into the dispenser by leading with the inside edge and pushing down and to the right. Do not force
the cups.
M
AIN
D
ETERGENT
C
OMPARTMENT
Pre-wash
Main-wash
Softener
NOTE: Reverse steps to install
cups and siphon caps and set up
dispenser for liquid detergent. Make
sure the siphon cap “snaps” into
place when installing it.
1 2 3 4