I-Data 5250 ALLY - Manual (Page 205)

Page B-23 APPENDIX B — SCS/DCA COMMAND SUMMARY
Command: Set Justify Mode (SJM)
Format: 2B D2 nn 0D st pr
Printers: 3812, 5219
Action: Set Justify Mode is used to activate and deactivate
justification.
The st parameter specifies whether justify mode is to be
activated or deactivated. An st value of 00h means no
change. An st value of 01h means activate justify mode.
An st value of 02h means deactivate justify mode.
The pr parameter specifies the percentage of white Space
at the end of the field to be redistributed within the field.
A pr value of 00h means no change.
Allowed values of pr are 00h, 32h (50%) and 64h
(100%).
When justification is active, Justify Text Field (JTF) is
not allowed.
When justification is active, subsequent text is justified
between the left and right margins.
Lines ended with any of the following combinations of
commands are considered to be the last line of a
paragraph and are not justified:
NL (or IRS) & NL (or IRS); RNL (or IRT); NL (or IRS)
& LF; NL (or IRS) & HT; NL (or IRS) & Indent Tab; NL
(or IRS) & Space; NL (or IRS) & Numeric Space; NL (or
IRS) & Required Space; NL (or IRS) & BS; NL (or IRS)
& UBS; NL (or IRS) & CR; NL (or IRS) & RLM; NL (or
IRS) & NBS; Required Form Feed.
Lines of text that extend past the right margin are not
justified.
IBMEMUL: Same as IBM.
The 5250 ALLY allows any percentage rule: 00h (no
change), and 01h (1%) to 64h (100%).
The 5250 ALLY turns off justify mode (as set by Set
Justify Mode) upon receiving this command.
The 5250 ALLY performs all calculations necessary to
perform the justification on the target printer.
275EMUL: No operation.