I-Data 5250 ALLY - Manual (Page 57)

Page 2-11 CHAPTER 2 — ADVANCED CONFIGURATION
!AGILE!43=00; 1 second
!AGILE!43=01; 5 seconds (default)
!AGILE!43=02; 10 seconds
!AGILE!43=03; 15 seconds
!AGILE!43=04; 30 seconds
!AGILE!43=05; 45 seconds
!AGILE!43=06; 1 minute
44 — Carriage Return at Form Feed
Some printers automatically perform a Carriage Return (CR) when they
receive a Form Feed (FF) command, while other printers do not perform
this function. This option provides users with two choices. If the user
chooses to add a Carriage Return, the 5250 ALLY will send a Carriage
Return every time it sends a Form Feed to the printer. This is the
appropriate choice if the printer does not perform a Carriage Return. If the
user chooses not to add a Carriage Return, a Carriage Return will not be
sent with a Form Feed. This choice assumes that the printer will perform
this function.
To program this option:
!AGILE!44=00; Do not add a CR
!AGILE!44=01; Add a CR at every FF (default)
46 — Vertical Movement
Some printers recognize a command to move the cursor to an absolute
position on the page, and others recognize a command to move a relative
distance from the current cursor position. Some printers recognize either
type.
Determine the type of parameter the printer recognizes for vertical
movement, and set the parameter appropriately. If the printer recognizes
both types of parameters, choose Absolute. This choice must be
coordinated with the definition given to the PFS that controls vertical
movement (PFS 0D — VERMOVE).
If the user would like the 5250 ALLY to send PFS 09 — LF to control
vertical movement, select Line Feed vertical movement.
To program this option:
!AGILE!46=00; Absolute vertical movement
!AGILE!46=01; Relative vertical movement (default)
!AGILE!46=02; Line Feed vertical movement