I-Data 5250 ALLY - Manual (Page 212)

AGILE 5250 ALLY User’s Guide and Reference Page B-30
Command: Page Presentation Media (PPM)
Format: 2B D2 nn 48 xxxx fc sd do dd pq dx
Printers: 3812, 4214, 5219
Action: Specifies parameters regarding the paper.
The fc parameter specifies the forms control. A value of
00h means no change to current setting; 01h specifies
paper; 02h specifies envelopes. For the 3812, the value
02h is not supported.
The sd parameter specifies the paper source drawer.
Valid values are 00h (no change), and from 01h to the
number of drawers installed in the printer.
The do parameter specifies the destination (output) tray
offset. A value of 00h means do not offset; any other
value means offset the tray. This parameter is supported
only by the 3812.
The dd parameter specifies the destination (output)
drawer. Valid values are 00h (no change), and from 01h
to the number of output drawers installed in the printer.
The 3812 jogs (offsets) the output tray if the value is
changed from the last setting.
The pq parameter specifies the print quality for
subsequent text. Valid values are 00h (no change), 01h
(data processing), 02h (near-letter quality) and 03h
(high-speed draft).
For the 5219, a value of 01h specifies ribbon-saver
mode.
For the 3812, a value of 01h allows Computer Output
Reduction, and values of 02h and 03h disallow COR. If
COR is disallowed, portrait mode is used instead.
The dx parameter specifies duplex mode. A value of 00h
specifies no change; 01h specifies simplex (one-sided)
printing; 02h specifies duplex (two-sided, side-binding)
printing; 03h specifies tumble (two-sided, top binding)
printing.
For the 3812, 4214 and 5219, the dx parameter is not
used.
This command is restricted to page boundaries.