Icom IC-V85-T - Manual (Page 32)

19
4
BASIC OPERATION
■
Setting audio/squelch level
D To set the audio level
Rotate [VOL] to set the desired
audio level while receiving a
signal.
• When no signal is received, push
and hold [MONI] while setting the
audio level.
• When [VOL] is assigned as tun-
ing dial, push [ Y Y ] / [ Z Z ] to adjust
the audio output level. (pgs. 18,
53)
D To set the squelch level
While pushing [MONI] , push
[ Y Y ] / [ Z Z ] to set the squelch
level.
• The squelch level “10” is tight
squelch, “1” is loose squelch and
“0” is open squelch.
• When [VOL] is assigned as tun-
ing dial, rotate [VOL] while press-
ing [MONI] . (pgs. 18, 53)
■
Receive and transmit
q Push and hold [PWR] for 1 sec. to turn the power ON.
w Adjust audio volume to the desired level.
e Set the frequency.
When a signal is received:
• Squelch opens and audio is emitted from the speaker.
• Signal indicator shows the relative signal strength level.
r Push [FUNC] , then [
H/M/L
](9) to select output power be-
tween high, middle and low.
• “H” appears when high power is selected.
• “M” appears when middle power is selected.
• “L” appears when low power is selected.
t Push and hold [PTT] to transmit, then speak into the micro-
phone.
• “$” appears.
•
Do not hold the microphone too close to your mouth or
speak too loudly. This may distort the signal.
y Release [PTT] to receive.
■
Monitor function
This function is used to listen to weak signals without disturb-
ing the squelch setting or to open the squelch manually even
when mute functions such as the tone squelch are in use.
➥ Push and hold
[MONI] to monitor the operating frequency.
The [MONI] key can be set to ‘sticky’ operation in
INITIAL
SET MODE . See page 55 for details.
DUP SCAN
PRIO SET H/M/L
OPT SKIP
BANK TONE T.SCAN P.BEEP
A B D C
CALL
ENT
MR CLR FUNC
PWR
9 8 7
4
1 2 3
5 6 0
MONI
DUP SCAN
PRIO SET H/M/L
OPT SKIP
BANK TONE T.SCAN P.BEEP
A B D C
CALL
ENT
MR CLR FUNC
PWR
9 8 7
4
1 2 3
5 6 0
[VOL]