Icom IC-V85-T - Manual (Page 59)

46
10
PAGER/CODE SQUELCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
• PERSONAL CALLS
This display appears when you are called with your ID code
and the calling station’s ID code is 123.
• GROUP CALLS
This display appears when you are called with the group
code, 888, and 888 has been programmed into code channel
C6.
• ERROR INFORMATION
When the transceiver receives an incomplete code, “E” and
previously received code appear.
■
Code squelch
When using code squelch you will only receive calls from sta-
tions which know your ID or group code. A 3-digit code is sent
each time
[PTT] is pushed in order to open the receiving sta-
tion’s code squelch prior to voice transmission.
q Set the operating frequency.
• Set the volume and squelch to the desired level as in normal op-
eration.
w Push [FUNC] , then push [ OPT ] (0).
• Rotate [VOL] to select “dtm.CS,” if “dtm.PG” or “dtm.OF” ap-
pears.
e Select the desired transmit code channel:
➥ Push and hold [ OPT ] (0) for 1 sec. to enter code selec-
tion mode.
➥ Rotate
[VOL] (or push [ Y Y ] / [ Z Z ] ) to select the desired
code channel.
➥ Push
[
✱
ENT ] (or [CLR] ) to exit code selection mode and
return to previous mode.
• 100 MHz digit shows “C.”
r Operate the transceiver in the normal way (push [PTT] to
transmit; release [PTT] to receive).
t To cancel the code squelch, push [FUNC] and [
OPT
] (0),
then rotate [VOL] to select “dtm.OF.”
• 100 MHz digit shows “1” when the function is cancelled.
Previously received code.
Code channel
“CP” and “ ” blink.
During channel number indication (described on page 20)
To use these functions in channel number indication, the
pager/code squelch setting must be programmed with other
memory contents before selecting channel number indication.