IBM SC34-5764-01 - Manual (Page 386)

fileid2
specifies the target file identifier, it may be a fully or partially qualified directory and file identifier.
DELETE
is a command that deletes an RFS file.
fileid
specifies the source file identifier, it may be fully or partially qualified.
DISKR
is a command that reads records from an RFS file.
stem
specifies the name of a stem. (A stem must end in a period.) Refer to section “Stems” on page 123 for
more information. The default stem is DATA.
DISKW
is a command that writes records to an RFS file.
GETDIR
is a command that returns a list of the contents of the current or specified directory into the specified
REXX array.
MKDIR
is a command that creates a new RFS directory level.
RDIR
is a command that removes the specified RFS directory.
RENAME
is a command that renames an RFS file to a new name.
fileid1
specifies the source file identifier, it may be a fully or partially qualified directory and file identifier.
fileid2
specifies the source target file identifier, it may be a fully or partially qualified directory and file
identifier.
Return Codes
0 Normal return
101 Invalid command
102 Invalid operand
103 File not found
104 Not authorized
105 File already exists
107 Insufficient space in file pool
110 Request failed
111 Invalid file ID
113 Directory not found
115 Directory already exists
116 Directory not specified
121 File corrupted
122 Invalid or out of range stem.0
126 Path error
127 CICS I/O error
128 Command not valid from this location
130 Directory not empty
131 Missing operand
132 Missing file pool data record. File pool is probably not formatted.
199 Internal error
Commands
364 CICS TS for VSE/ESA: REXX Guide