Cornelius SID851A/250S - Manual (Page 18)

15
90914
6. Push manual water fill switch and fill evaporator with water (approximately 5 seconds).
7. Put the “Clean/Run”switch in the “clean”position. Allow unit to run in the cleaning mode for at least 30
minutes.
8. Put the “Clean/Run”switch in the “run”position.
9. Depress the “Flush”switch push button and drain evaporator for about 1-1/2 minutes. Release push but-
ton. Push manual water fill switch and allow evaporator to refill with water. Repeat Step 9 three (3) times to
thoroughly remove cleaning solution from evaporator.
10. Depress the “Flush”switch push button for 1-1/2 minutes to drain the evaporator.
11. Remove the evaporator plug.
12. Put the “Stop/Run”switch in the “run”position and allow unit to run through at least three (3) complete ice
making cycles or until ice is free of “sweet”taste.
WARNING: If unit fails to harvest ice, put the “Stop/Run” switch in the “stop” position.
Depress the “Flush” switch push button for 1-1/2 minutes to drain the evaporator. Flush
the evaporator with hot water to thoroughly melt all the ice in the evaporator. Repeat Step 9
to remove all traces of the cleaning solution from the evaporator.
13. Dispense all ice out of storage hopper and discard.
Dispenser Section
1. Turn off main electrical power supply to machine.
2. Remove agitator assembly from storage hopper and wash and rinse it thoroughly.
3. Wash down all inside surfaces of the ice storage area, including the top cover and ice drop cover with a
mild detergent solution and rinse thoroughly to remove all traces of detergent.
4. Replace agitator.
5. Remove ice chute cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift ice chute cover to disengage upper pins.
C. Lower ice chute cover down out of unit. Note: It may be helpful to twist cover slightly.
6. Clean the inside of the ice chute and ice chute cover with a mild detergent solution. Rinse thoroughly to
remove all traces of detergent.
7. Reverse steps above to reassemble ice chute.
8. Sanitize the inside of the hopper agitator, ice chute, the hopper cover and ice drop cover with a solution of
1 ounce of household bleach to 2 gallons of water. (200 PPM)
9. Replace the hopper cover and ice drop cover. Turn on the electrical power supply. The ice maker is ready
for normal operation.
For Units With Beverage System
Cold Plate
1. Carefully remove the lower front panel. (Below beverage faucets).