IBM 5000 - Manual (Page 114)

Removing the Rack Model from a Rack Enclosure
To remove the Netfinity 5000 server from a rack enclosure:
1. Remove the screws from each front bracket. Set the screws aside for later
use.
2. Slide the server out of the rack.
3. If you have a modem or fax machine attached to the server, disconnect the
telephone line from the wall outlet and the server.
Note: If you are in the United Kingdom, you must perform this step before
disconnecting the power cord.
4. Disconnect all cables and power cords from the rear of the server.
5. Remove the two screws from the cable-arm bracket.
6. Press the safety release latch on each slide rail.
7. Lift the server at a slight angle, and pull it from the slide rails. Then place the
server on a flat, nonconductive surface.
Chapter 5. Installing a Server in a Rack Enclosure 105