IBM 5000 - Manual (Page 80)

Installing Microprocessors
10. Go to “Record the Identification Numbers” on page 162 and Table 14 on
page 164, and update the microprocessor information; then, return here.
11. Because you installed a new microprocessor in your server, you must
reconfigure your server. Follow the procedure described in “Using the
Configuration/Setup Utility” on page 22.
12. Because you installed a new microprocessor in your server, you might need to
make changes to your operating system.
If your operating system does not support SMP, install one of the SMP
operating systems that your server supports. See
http://www.pc.ibm.com/netfinity/ on the World Wide Web.
If your operating system does support SMP, refer to your operating-system
documentation. You might need to make changes so that the operating
system recognizes the new microprocessor.
On some operating systems, if you install a second microprocessor it might
be necessary to reinstall the operating system. See the documentation that
comes with the new microprocessor.
13. If you want to install or remove any other options, do so now. Otherwise, go to
“Completing the Installation” on page 76.
Table 3. Switch Settings for Microprocessor Speed
350 MHz
1 2 3 4 5 6 7 8
ON
OFF
400 MHz
1 2 3 4 5 6 7 8
ON
OFF
450 MHz
1 2 3 4 5 6 7 8
ON
OFF
70 Netfinity 5000 Server Hardware Information and Procedures