IBM CICS Transaction Server for OS/390 SC33-1686-02 - Manual (Page 45)

CEBT SET AUXTRACE
CEBT SET AUXTRACE
Function: Change auxiliary tracing options.
Description: You can start, stop, or pause tracing, and
specify that automatic switching of the auxiliary data set is to
occur when needed. You can use the switch option to
change the data set.
Instead of using the SET command, you can overtype your
changes on the INQUIRE screen after tabbing to the
appropriate field (see “Overtyping a display” on page 47).
For information about using traces, see the CICS Problem
Determination Guide.
Syntax: Press the Clear key to clear the screen. There are
two ways of commencing this transaction:
Type CEBT SET AUXTRACE (the minimum abbreviation is
CEBT S AUX ). You get a display that lists the current
status, similar to that obtained by CEBT INQUIRE
AUXTRACE. You can then tab to the highlighted or
blank fields and overtype them with the required values.
Type CEBT SET AUXTRACE ( CEBT S AUX ) followed by one
or more attribute settings that you wish to change. For
example,
CEBT S AUX STO will stop auxiliary tracing if it is
already running.
─ ─ ─CEBT Set Auxtrace ─ ─┬ ┬ ─────── ──────────────
├ ┤ ─STArt─
├ ┤ ─Pause─
└ ┘ ─STOp──
─ ─ ─┬ ┬ ────────── ─ ─SWitch ─
├ ┤ ─NOswitch─
├ ┤ ─NExt─────
└ ┘ ─All──────
Options
All
Specifies that automatic switching between the two
auxiliary trace data sets is to occur as necessary until
the end of this CICS session, without the need for
operator intervention.
NExt
Automatic switching of the auxiliary trace data set is to
occur when the current trace data set is full, but not
subsequently.
NOswitch
Switching between the auxiliary trace data sets is not to
occur without operator intervention.
Pause
Auxiliary tracing is to stop, but the data set is to remain
open. A subsequent START request causes trace
entries to be written immediately following those that
were written before the PAUSE request.
STArt
CICS is to start auxiliary tracing and open the auxiliary
trace data set if it is currently closed.
STOp
CICS is to stop auxiliary tracing and close the auxiliary
trace data set. A subsequent START request causes
new trace entries to be written at the start of the data
set, thereby overwriting the trace entries that were
written before the STOP request.
SWitch
specifies that an immediate switch from the current
auxiliary trace data set is to be made to the alternate
trace data set.
Chapter 7. Master terminal (alternate CICS) CEBT 27