ICP DAS USA IM-100 - Manual (Page 49)

Selected the active polarity mode
and user can refer 1.4.9 for Strobe
Control polarity definition.
Setting the delay value in
necessary and please refer
1.4.9.for the formula of delay time.
Setting the strobe duration and
time base and please refer 1.4.9
for the formula of duration time.
„ Motion
Virtual Trigger
Enable the check box while used
FRNET for I/O trigger simulation.
Selected the output port of FRNET
and ensure the wiring correctly.
Setting the trigger pulse frequency
of FRNET.
Physical Trigger
Note – Please refer the Hardware Installation of P T-M8194H for the
wiring of motion in position signal output to MAVI
ISO-PS400 or E
S trigger input port.
Enable the check box while used
PISO-PS400 or ET-M8194H for
received the in position signal from
encoder / sensor.
Enable the check box of Trigger
Compare and setting the Total
Pulse and Trigger Pitch for
equidistance trigger.
Enable the check box while active
the trigger pulse i n randomized.
- 49 -