Intellinet Network Solutions 523615 - Manual (Page 5)

5
straight-through or cross cable can be used to connect the LAN card or switch.
3. Turn on the power by pressing the power button on the back of the router. The
device will perform a self test. During the self test, the PWR LED, CPU/RUN LED
and LAN port LEDs of connected ports are lit. After the self test, the CPU/RUN LED
starts flashing (on-off-on-off).
4. Start the computer.
2.3 Indicators and Connections
2.3.1 Model 523608, 4-Port
LED Indication
PWR Continuously lit indicates power to the router.
RUN/CPU Slowly blinking indicates the system is operational after a proper startup.
WAN
Blinking indicates data is being transmitted to/from the Wide Area
Network.
1–4 Blinking indicates data is being transmitted to/from the Local Area
Network.
Port/Jack Indication
DC 5 V
Connects to the power adapter.
Reset This can be to restart the router, but all configurations that may have
been entered will be restored to the original factory defaults.
WAN Connects xDSL/cable modem or special cable.
1–4 The LAN ports connect to PCs, hubs, switches and so on.