Intermec CN2G - Manual (Page 41)

Chapter 2 — Configuring the CN2G
CN2G Handheld Computer User’s Manual 29
To use USB communications with your CN2G
1 Connect the communications dock to the USB port of the
other device using an appropriate USB cable.
2 Make sure that your USB device is configured for USB
communications.
3 Insert the CN2G into the communications dock.
4 Turn on the CN2G.
For more information about the communications dock, see the
instructions that ship with the communications dock.
Configuring 802.11b/g Radio Communications
Make sure all components with antennas are at least 30 cm
(1 ft) apart when power is applied. Failure to comply could
result in equipment damage.
The wireless CN2G has an internal 802.11b/g radio to transfer
data using wireless communications. This section of the manual
assumes that you have already set up your wireless
communications network including your access points. If you
are using a UDP Plus network, you also need to have your
Intermec Application Server communicating with a host
computer.
Your CN2G supports these network protocols:
• TCP/IP
• UDP Plus
The next sections explain the parameters you need to configure
for the CN2G to work in your wireless network.