IBM AA-RWF3A-TE - Manual (Page 119)

Taiwan battery recycling notice
The Taiwan EPA requires dry battery manufacturing or importing firms in accordance
with Article 15 of the Waste Disposal Act to indicate the recovery marks on the batteries
used in sales, givaway, or promotion. Contact a qualified Taiwanese recycler for
proper battery disposal.
Power cords
The power cord set must meet the requirements for use in the country where the product
was purchased. If the product is to be used in another country, purchase a power cord
that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on
the product electrical ratings label. The voltage and current rating of the cord should
be greater than the voltage and current rating marked on the product. In addition, the
diameter of the wire must be a minimum of 1.00 mm 2 or 18 AWG, and the length of the
cord must be between 1.8 m, (6 ft) and 3.6 m (12 ft). If you have questions about the
type of power cord to use, contact an HP authorized service provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items
placed upon or against them. Pay particular attention to the plug, electrical outlet, and
the point where the cords exit from the product.
Japanese power cord statement
SAN Switch installation guide 119