iSymphony M110 - Manual (Page 12)

21 22
CD OPERATION
Normal Playback
Press the FUNCTION button to select “CD” function.
Press the OPEN/CLOSE button on front panel to open the CD tray.
Load a disc into the player with the printed label facing out.
NOTE: The reading time may be longer if you are using CD-R or CD-RW discs. This is normal
and not an indication of any problem with your unit.
Press the OPEN/CLOSE button to close the CD tray.
The display will show flashing “READ” as the player
reads the Table Of Contents on the disc.
In stop mode, press the PLAY/PAUSE button to begin
playback.
Playback will continue until all tracks on the disc have been
played, then the player stops and the display shows the total
tracks number and playing time on the disc.
To stop playback at any time, press the STOP/BAND button.
Pause Control
Skip Track and High Speed Music Search
During playback, repeatedly press the SKIP/TUNING or buttons to skip to higher or
lower numbered tracks. Playback will begin on the selected track.
During playback, depress and hold the SKIP/TUNING or buttons to search within a
track at high speed to locate a specific musical passage.
Release the SKIP/TUNING or buttons when you hear the desired passage.
Normal speed playback will resume at that point.
To pause temporarily during CD playback
The sound stops and the elapsed time flashes in the display,
but the disc continues spinning.
Press the PLAY/PAUSE button once more to cancel Pause
mode and resume playback at the same point. The elapsed time
stops flashing.
Press the PLAY/PAUSE button.