iSymphony M110 - Manual (Page 9)

OPERATING INSTRUCTIONS
Make sure that you have fully extended the FM antenna wire.
Make sure that you have installed batteries in the remote control handset.
Make sure that the system is connected to an AC outlet that is always “live”.
Do not connect the system to an AC outlet controlled by a wall switch.
Most of the main functions of this system can be operated by the controls on the front panel of the
main unit, or by the buttons on the remote control handset. If a specific function can only be
operated by the remote handset, or by the front panel controls, this will be clearly indicated in the
instructions.
General Controls
The effective operating range of the remote control is approximately 15 feet. Please note that bright
sunlight or room lighting may interfere with the remote control operation. If the remote is not operating
properly try reducing the brightness of the room or moving closer to the main unit. If this does not
solve the problem, it may be time to change the remote control battery.
When operating this system with the remote control handset make sure that the IR (Infrared)
transmitter on the front of the remote handset is pointed at the remote sensor on the front panel of
the main unit.
15 16
Volume Controls
The preset equalizer allows you to adjust the sound characteristic for the most popular types of music.
Press the DBBS button to increase the bass response “BBS-ON” appears briefly on the display
and “X-BASS” remains in the lower left of the display.
Press again to cancel the Bass Boost function.
Press the MUTE button on the remote control to shut off the
speakers temporarily.
The sound stops and the “MUTE” indicator flash in the display.
Press the MUTE button again to cancel the mute function and
restore the sound. The “MUTE” indicator disappears.
The mute function will also be canceled automatically by pressing
the VOLUME + or VOLUME – buttons.
To increase or decrease the system volume
EQ (Electronic Preset Equalizer)
When the power is switched off automatically returns to the same level when the power is switched
on again.
DBBS (Dynamic Bass Boost) Control
Press the EQ button to cycle through the following equalizer settings:
FLAT, CLASSIC, ROCK, POP, JAZZ.
MUTE Button (On Remote Control Only)
The appropriate EQ indicator briefly appears on the display to confirm
your selection, and your selection is shown at the bottom of the display.
The system remembers the EQ setting when the power is switched off
and returns to the same setting when the power is switched on again.
Press the VOLUME + or VOLUME – buttons on the remote control
or turn the VOLUME Control on the front panel.
The Volume Level Indicator will appear on the display when you
change the volume level. The level indicator ranges from VOL MIN
to VOL MAX.
Note : If VOLUME setting is over 26 when the unit is turned off,
it will revert to 26 when the unit is turned on again.