iSymphony M110 - Manual (Page 13)

24 23
Repeat Playback (On Remote Control Only)
The Repeat function in this system allows you to continuously repeat a single track, or the entire disc.
The Repeat function can be activated during playback or while the player is stopped.
One Track Repeat
Select the track to be repeated and begin playback.
Press the REPEAT button on remote control once.
The indicator appears in the display and the selected
track will be repeated continuously.
All Tracks Repeat
Load the disc in the player and begin playback.
Press the REPEAT button on the remote control twice.
Random Playback (On Remote Control Only)
The Random playback feature allows you play all the tracks on the disc in random order. You can
select random playback while the disc is playing or when the player is stopped.
Load a CD in the player as usual and then press the RANDOM button on the remote control
handset.
The “RNDM” indicator appears in the display.
The player will randomly select a track from the disc and begin
playback. Random playback will continue until all tracks have
played once, then the player stops.
To stop Random playback, press the RANDOM button on the remote control again.
The “RNDM” indicator disappears and normal playback will resume from that point.
The ALL indicator appears in the display. All tracks on
the disc will be repeated continuously.
To cancel Repeat playback mode press the REPEAT button until the ALL indicators
disappear from the display.
Repeat mode can also be canceled by opening the CD tray, switching to the TUNER or AUX
mode, or pressing the STANDBY / button to return the system to the Standby (Off) mode.
INTRO Scan Play back (On Remote Control Only)
This feature allows you to play just the first 10 seconds of each track on the disc. This may be useful
when you are trying to locate a specific song but you do not remember the track number.
Load the disc as usual and wait until the display shows the total playing time and number of tracks.
Press the MENU/INTRO button on the remote control.
The player will play the first 10 seconds of each track
automatically. When the first 10 seconds of the last track has
played the player stops and the display again shows the total
playing time and number of tracks on the disc.
The “INTRO” indicator will appear in the display.
To cancel the Intro mode press the MENU/INTRO button once more until the “INTRO” indicator
disappears.
Programmed Playback
The Programmed Playback feature allows you to program a total of up to 64 tracks in any desired
order. You may program the same track to play several times within a program sequence if desired.
Note: You cannot program tracks during playback. If a disc is playing press the STOP/BAND
button first to stop playback before beginning the programming steps below .
1. Load the disc in the player and wait until the player has read
the Table of Contents of the disc.
2. Press the PROG/CLK button.
The “PRG” indicator, Program Memory “P- 01” and Track
“001” will appear in the display .
3. Then press the SKIP/TUNING or buttons to
select the first track on the disc to be programmed.
Example: Track 07
4. Press the PROG/CLK button again to enter Track 07 in
program memory #1. The program memory number
advances to “P- 02”.
5. Repeat steps 3 and 4 selecting the desired Track number each time until you have entered up to
64 tracks in the CD program memory.