iSymphony M110 - Manual (Page 7)

11 12
This system includes a subwoofer output jack on the rear panel labeled “SUBWOOFER OUT”. You
may connect an external, powered subwoofer using a single RCA-type cable as shown below.
This system includes a pair of LINE OUT (R/L) jacks for the connection to external equipment.
LINE OUT
LINE IN
Cable (not included)
Plug x2 Plug x2
To LINE-IN Jacks of
external equipment
Line Output Jacks
Connect as shown below.
Connecting a Subwoofer
Video Connections
This system includes two video output jacks on the rear panel:
Composite video output labeled “VIDEO OUT”
S-VIDEO output labeled “S-VIDEO OUT”.
These connectors allow you to send the video signal (still images or movies) only from a capable iPod
to a connected TV. Other video output is not supported. Connections are made as below using either
RCA-type or S-VIDEO type cables, not included.
This system includes a stereo PHONES jack on the front panel of the main unit. You may connect a
set of stereo headphones, not included, to this jack for private listening without disturbing others.
The main speakers are automatically shut off when headphones are connected to the PHONES jack.
Make sure that the plug from your headphones is fully inserted into the headphone jack. If the plug is
not fully inserted the sound may be intermittent, or you may only hear sound from one side of the
headphones.
IMPORTANT: To prevent hearing damage always set the volume control to a low level before you
connect the headphones. Then connect the headphones, put them on, and very gradually increase
the volume to a comfortable listening level. Remember that CDs may contain both very soft and very
loud passages. Adjust the volume to a comfortable level using a louder passage, so that you always
know what the maximum level will be.
Connecting Stereo Headphones
Powered Subwoofer
Cable (not included)
SUBWOOFER
OUT
To S-VIDEO input of TV
TV
Cable (not included)
OR
TV
To composite video
input of TV
Cable (not included)
S-VIDEO OUT
VIDEO OUT