Integra DPC-8.5 - Manual (Page 16)

16
Getting to Know the DPC-8.5 —Continued
J Play indicator (31)
This indicator is shown during playback.
K
Pause indicator (31)
This indicator appears when playback is paused.
L Title & group number
Title and group numbers appear here.
M Chapter & track number
Chapter and track numbers appear here.
N
Time display
Time information, such as total time, remaining
time, and so on, is displayed here in hours, minutes,
and seconds. Other messages are also displayed.
O MP3 indicator
This indicator appears while an MP3 track is being
played.
P Dolby Digital ( D), Dolby Pro Logic
( PL) & DTS ( ) indicators
The Dolby Digital indicator ( D) appears when
a Dolby Digital soundtrack is selected. The Dolby
Pro Logic ( PL) indicator appears when the
DPC-8.5’s Dolby Pro Logic decoder is on. The DTS
indicator appears when a DTS soundtrack is
selected.
Q
DISC indicators 1–6 (29)
These indicators show how many discs are loaded.
When the disc tray is closed, all of the disc indica-
tors appear until the DPC-8.5 has checked each bay
for the presence of a disc. If a bay is found to have
no disc, the corresponding indicator disappears.
For detailed information, refer to the pages in
parenthesis.
A
VIDEO OUTPUT 1 & 2 (21)
These sockets output composite video and can be
connected to a composite video input on a TV or
projector.
B S VIDEO OUTPUT 1 & 2 (21)
These sockets output S-Video and can be connected
to an S-Video input on a TV or projector.
C D.MIX AUDIO OUTPUT (21, 24)
These sockets output analog audio and can be con-
nected to a stereo analog audio input on a TV, hi-fi
amp, or other component. If the source audio is
multichannel (Dolby Digital, DTS, DVD-Audio,
SACD), they output a 2-channel downmix.
D FRONT, SURR 1, CENTER & SUBWOOFER
AUDIO OUTPUT (23)
These sockets output 5.1-channel analog audio and
can be connected to a 5.1-channel analog audio
input on an AV receiver, surround sound decoder
(Dolby Pro Logic), or other component. The
FRONT outputs can be used as either front outputs
or downmix outputs (see page 58).
E SURR 2 AUDIO OUTPUT (23)
These sockets output the same analog audio as the
SURR1 outputs and can be connected to the analog
surround back left and right inputs on a 7.1-channel
AV receiver or other component. When using these
sockets, the SURR MODE switch should be set to
1+2.
F SURR MODE (AUDIO OUT) switch (23)
This switch is used to set the surround output mode
of the analog multichannel audio outputs. If you
connect the SURR 2 outputs to a 7.1-channel AV
receiver or amp, set this switch to 1+2. This reduces
the output level by 3 dB. If you’re not using the
SURR 2 outputs, set it to 1.
Rear Panel
L
R
9 J L K N M
2 1 8 6 7 5 4 3