Integra DPC-8.5 - Manual (Page 17)

17
Getting to Know the DPC-8.5 —Continued
G RS232 port
This bidirectional RS-232 port can be connected to
an external controller.
H AC INLET (26)
The supplied power cord should be connected here.
I
OPTICAL DIGITAL AUDIO OUTPUT (24)
This optical digital audio output can be connected to
an optical digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS). The Digital Out/Digital1 setting on page 56
is used to configure this output.
J COAXIAL DIGITAL AUDIO OUTPUT (24)
This coaxial digital audio output can be connected
to a coaxial digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS). The Digital Out/Digital2 setting on page 57
is used to configure this output.
K IR IN/OUT (25)
The IR IN socket can be used to connect a commer-
cially available IR receiver, which can be used to
pickup signals from the remote controller when the
DPC-8.5 is located in another room, installed in a
rack, or is out of range of the remote controller
The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
used to pass remote controller signals received by
the IR IN along to other components.
L
REMOTE CONTROL (24)
These (Remote Interactive) connectors can be
connected to the connectors on your other Inte-
gra AV components for interactive control.
To use
you must make an analog audio connec-
tion (RCA) between the DPC-8.5 and your Integra
AV receiver, even if they are connected digitally.
M
COMPONENT VIDEO OUTPUT 1 (21)
These sockets output component video and can be
connected to a component video input on a TV or
projector.
N COMPONENT VIDEO OUTPUT 2 (21)
These sockets output component video and can be
connected to a component video input on a TV or
projector.