Integra DPC-8.5 - Manual (Page 25)

25
Connecting the DPC-8.5 —Continued
You can use the following multiroom kits to control the
DPC-8.5 when it’s out of range of the remote controller:
• Onkyo Multi-Room System (IR Remote Controller
Extension System)
• Multiroom AV distribution and control systems such
as those made by Niles and Xantech.
Controlling the DPC-8.5 When It’s Out of
Range
If the DPC-8.5 is located in another room, installed in a
cabinet, or is out of range of its remote controller, you
can use a commercially available IR receiver to pick up
the remote controller signals and feed them to the
DPC-8.5, as shown below.
Connect the IR receiver to the DPC-8.5 as shown below.
Controlling Other Out-of-range
Components
For another component that is out of range of its remote
controller, you can use a commercially available IR
emitter to retransmit the remote controller signals
received at the DPC-8.5’s IR IN, as shown below.
Connect the IR emitter to the DPC-8.5’s IR OUT, and
place the IR emitter in front of the other AV component’s
remote control sensor (usually located on its front
panel), as shown below. See the instructions supplied
with the IR emitter.
Only remote controller signals received by the
DPC-8.5’s IR IN are fed through to the IR OUT. Signals
picked up by the DPC-8.5’s remote control sensor are
not.
Controlling Components That Are
Out of Range
L
R
OUT
IN
IR
IR IN
DPC-8.5
Inside
cabinet
Remote controller
Connecting
block
IR receiver
Signal flow
OUT
IN
IR
DPC-8.5
from connecting block
Miniplug cable
Signal flow
IR IN
IR OUT
Connecting
block
IR receiver
DPC-8.5
IR emitter
Remote controller
Other
component
Signal flow
OUT
IN
IR
Signal flow
DPC-8.5
Remote control
Other component
sensor from connecting block
Miniplug cable
Miniplug
IR emitter
IR Emitter