IBM SC33-1683-02 - Manual (Page 460)

NOEXITS
No branches are taken to user routines.
TIME|NOTIME
specifies whether threshold tests are to be controlled over prescribed time
intervals. An example might be putting a terminal out of service if more than
three instances of a given type of error occur in one hour. The parameter
must be the same as the OPTIONS operand in the DFHTEPT
TYPE=INITIAL macro.
TIME
This type of threshold testing is supported.
NOTIME
This type of threshold testing is not supported.
TCAM|NOTCAM
specifies whether optional TCAM support is to be included.
TCAM
TCAM error code ‘9F’ is supported.
NOTCAM
TCAM error code ‘9F’ is not supported.
PRINT=print-information
specifies which types of information are to be logged to the transient data
destination each time an error occurs. If NOTD is specified on the OPTIONS
operand, all PRINT parameters default to NO. All PRINT parameters require the
transient data output routine. The parentheses are required even when only one
parameter is specified.
ERRORS|NOERRORS
specifies whether unprocessable conditions detected by the sample
DFHTEP are to be recorded on the transient data destination.
ERRORS
Error messages are to be logged.
NOERRORS
No error messages are to be logged.
TACPACTION|NOTACPACTION
specifies whether DFHTACP default actions are to be recorded on the
transient data destination.
TACPACTION
The default actions are logged.
NOTACPACTION
No default actions are logged.
TEPACTION|NOTEPACTION
specifies whether the actions selected as a result of sample DFHTEP
processing are to be recorded on the transient data destination.
TEPACTION
The final actions are logged.
NOTEPACTION
No final actions are logged.
the sample terminal error program
428 CICS TS for OS/390: CICS Customization Guide