IBM SC33-1683-02 - Manual (Page 468)

DFHTEPT TYPE=BUCKET–using the error bucket for specific
errors
The DFHTEPT TYPE=BUCKET macro is used to ensure that specific error
conditions are always accounted for in the common error bucket:
TYPE=BUCKET
generates the macro to account for specific error conditions in the common
error bucket. If MAXERR=25 on the DFHTEPT TYPE=INITIAL macro, this
macro cannot be used. This macro is not required if no error codes are to be
specifically accounted for in the common error bucket. Each error code must be
identified by a separate DFHTEPT TYPE=BUCKET macro.
CODE=errcode
identifies the error code to be specifically accounted for in the common error
bucket. The error code must not be specified in the DFHTEPT
TYPE=PERMCODE or TYPE=ERRCODE macro.
DFHTEPT TYPE=FINAL–terminating DFHTEPT entries
The DFHTEPT TYPE=FINAL macro terminates the generation of the DFHTEP
tables.
DFHTEPT–examples of how the macros are used
1. The following is an example of the minimum number of statements required to
generate the TEP tables:
DFHTEPT TYPE=INITIAL,MAXTIDS=10
DFHTEPT TYPE=FINAL
END
This example generates 10 reusable terminal error blocks, each capable of
accounting for the maximum number of error types. Time threshold control is
supported, and all threshold values are the defaults supported by the sample
DFHTEP. This is equivalent to the CICS-supplied sample terminal error
program.
2. Figure 20 on page 437 is an example of a customized TEP table (continuation
characters omitted).
DFHTEPT TYPE=BUCKET
,CODE=errcode
DFHTEPT TYPE=FINAL
the sample terminal error program
436 CICS TS for OS/390: CICS Customization Guide